Nowadays, mechanical equipment has replaced traditional manual work in a wide range. In terms of landscaping, many workers use tea plucking machine wholesale to trim the lawn, which mainly relies on blades to trim the lawn. So do you know what use requirements tea plucking machine wholesale blades should meet? If you don't know, take a look at the following introduction:

1, the grass cutting height should be adjusted according to the actual requirements, so that it can adapt to the height, if the required lawn pruning is relatively low, then the blade should be low requirements.

2, the lawn should be manicured and smooth. Within the same travel range, the height of the grass cutting before and after should be consistent, and the two operation trips should be smooth and without stubble when they are connected.

3, should have a strong terrain adaptation ability, copying ability should change with the terrain. The grass should be cut at the same height before and after.

4, the blade on the lawn should be light, as far as possible to avoid damage to the grass.

5, grass clippings should be collected clean, and some equipment has the function of breaking grass, which requires the fine fragmentation of the grass to be cut, and when the grass clippings are scattered in the lawn as fertilizer, the grass should be required to be decomposed in time.

6, the quality of the blade should be qualified, the quality of the lawnmower is better, the probability of failure is small, and the requirements can save fuel and high efficiency.

7, tea plucking machine wholesale blade should be convenient to operate, the grass cutting machine is also required to be easy to operate, maintenance and debugging to be convenient, the parts used should have universality and interchangeability.

Many staff found that when using tea plucking machine wholesale to mow the lawn, tea plucking machine wholesale manual fire after a few minutes, start again, find it difficult to start, start, the operation is not stable, how is this?

tea plucking machine wholesale works for a long time, during which it is very stable, but suddenly fails to start the next time, or the operation is unstable after starting, which may be because of the performance of oil leakage. Some tea plucking machine wholesale, at the beginning of the operation is unstable, but after a period of time, the equipment returns to a stable state, which may be because the material thermal expansion and cold contraction speed is inconsistent.

The intake connection structure of tea plucking machine wholesale is crankshaft box - intake pipe - carburetor - air filter. Among them, the crankshaft box part is metal, the intake pipe part is plastic, and the thermal expansion and contraction speed of these two materials is not the same.

At the beginning of the startup, the temperature of the equipment changes slowly when it is low to high temperature, so the equipment is relatively stable, but when the equipment is turned off, it starts immediately after a while, because it changes from high temperature to low temperature and then back to high temperature, which will lead to the difference between the thermal expansion and cold contraction speed becoming larger, resulting in the increase of the gap between parts and air leakage.

If the tea plucking machine wholesale cannot be started, it can be started again after a period of time, or the intake pipe of the appropriate material can be replaced and the structure of the intake pipe can be re-equipped. However, the latter two require greater costs, so the former method is used more often.

tea plucking machine wholesale https://www.keylead.cn/Electrical-Tea-Plucking-Machine